Haier Dishwasher Error Codes Explained

If your Haier dishwasher is beeping it's simply telling you that there’s an operational issue that needs to be resolved. The beeping may be accompanied by the display of an error code or flashing lights. Bear in mind that depending on your model error descriptions may vary and you should consult your manufacturer's manual if your code isn’t included below.

Haier dishwasher error codes

Haier dishwasher error codes are explained in more detail here...

E1: First and second lights flashing

This indicates an error with the door with something preventing it from closing securely. This could be related to a faulty door switch or door latch.

E2: First and third lights flashing

Your dishwasher has detected that the water temperature sensor has failed which results in the temperature of the water inlet becoming out of range.

E3: First and third lights flashing

There is insufficient water detected in your appliance causing your dishwasher not to start the wash cycle. This may require the drain hose to be adjusted preventing draining during operation.

E4: First, third, and fourth lights flashing

Haier dishwasher E4 error code is triggered by a failure to drain and can be caused by a defective drain pump or filter, or an obstructed drain hose.

E5: First, second, and third lights flashing

This points to an issue with your dishwasher filling. It could be related to low water pressure, a problem with the water supply hose, or a blocked water inlet filter. The water inlet solenoid could also be defective.

E6: All four lights flashing

Haier dishwasher E6 error code indicates that the flood protection device has been activated and the water supply will need to be turned off, stopping any more water from flowing into the dishwasher and leaking out.

E7: First, second, and fourth lights flashing

This is a problem with internal communication between the control boards and your dishwasher will need to be turned off and a repair expert called in.

E8: Second and third lights flashing

A water level sensor fault will cause these error responses and will need the help of an experienced engineer to repair or replace the part.

E9: second light flashing

This is a half load diverter fault that isn't available on all models.

The above issues will all need resolving by a professional.

Haier dishwasher troubleshooting

Haier dishwasher common problems include:

Haier dishwasher won’t start

If the door isn’t securely closed your dishwasher won’t start. Other issues include blown fuses, damaged wiring, faulty sockets, and the incoming power supply.

Haier dishwasher not cleaning properly

Blocked filters can cause this issue. Remember that a too high dosage of the rinse aid can result in white streaks or blue layers on glasses and dishes, and not enough can cause dry water drop stains.

Haier dishwasher buttons not working

If some of the buttons are working but others don't, it’s likely that the touchpad is faulty and will need replacing. Otherwise, the culprit may be the main control board.

Haier dishwasher not draining

This may be related to an obstructed drain hose, blocked filter, or defective drain pump.

Need Haier dishwasher repairs in London?

You’ll be able to get Haier dishwasher repair from trusted specialists in London. If you have an urgent issue you’ll be able to arrange an emergency appointment, and you won’t need to pay a deposit or a call-out fee. Your work will be carried out under full protection cover, and every repair comes with a guarantee that lasts for six months.