Maidaid Dishwasher Problems And Troubleshooting

A Maidaid Halcyon dishwasher is designed for maximum energy and wash efficiency with a water tank intended to reduce water consumption. New models have large control buttons and are supplied with two open glass racks. With suitability for hot or cold-water supplies, extended cycle times, and optional drain pumps this is a commercial kitchen appliance must have!

One of the key benefits in investing in a Maidaid dishwasher is their ability to wash large quantities of kitchenware in a short time. So, when things go wrong this can have a detrimental effect on your business. See a range of Maidaid dishwasher problems and troubleshooting here…

Maidaid dishwasher error codes

Appliances are equipped with a self-diagnosis system that can detect and signal a series of problems. Your manufacturer's installation and user guide will list every error code, but a range of error codes are highlighted below:

This code will display when the water won’t drain or drains abnormally. Reasons may be issues with the overflow, a damaged or obstructed drain hose, or a clogged siphon or filter. After checking all of these components another drain cycle should be attempted.

This indicates that the boiler hasn’t filled and the boiler loading has timed out, making it impossible to perform a rinse. The water tap will need to be checked to make sure that it’s open before a new complete cycle is run.

If your display is showing this error code it’s related to a boiler-rinse time-out which means that there may be an issue with the rinse pump, the rinse nozzles, or the boiler pressure switch system.

Maidaid dishwasher troubleshooting

The most common dishwasher faults are identified here:

Often an electrical issue this could be problems with the power supply, a blown fuse, or a defective power socket. Any electrical concerns should be safely dealt with by a qualified electrical engineer.

The dishwasher door may also be the culprit. If the latch won’t close securely this will prevent the appliance from starting. Another component to check is the motor which may be stuck. Spinning the motor by hand with the appliance turned off at the power will ensure that it can move freely.

This is often related to the door not closing securely with the door gasket being cracked or damaged in some way. Food debris can also stop the door from sealing completely. The gasket may need to be replaced.

The mechanism that indicates the level of the water in the dishwasher is known as the float switch. If this becomes permanently stuck down it can result in the dishwasher overfilling and leaking onto the floor. If this is the case a thorough clean may do the job – otherwise, the switch may need to be repaired or replaced.

This is typically caused by a defective heating element or the high-lit thermostat that stops the dishwasher from getting too hot. A malfunctioning high-limit thermostat can cause the heat to be shut off before your tableware is completely dry.

A multimeter can be used to check the device and if working correctly you should take a look at the rinse aid dispenser. If this is empty or not dispensing properly this can also cause the dishes to remain wet.

Maidaid dishwasher repair

Contact a recommended repair and service company to get a fast and efficient fix – all engineers will be fully qualified and experienced in regularly repairing and servicing Maidaid dishwashers. Your appliance will soon be up and running as new!